Rebar bending machines are used on construction sites and generally require someone to look after them. If there are more steel bars to be processed, professionals are needed to arrange reasonable work. From the right side of the rebar bending machine, the coiled rebar is continuously pulled into the hole of the machine, the bent rebar is straightened, and then the straightened rebar is placed on the operating table of the rebar bending machine for processing. Put them in stirrups. The machine transports them to the prescribed place in the building. Straightening and forming rebar is a relatively large task. If the demand for rebar is high, thousands of finished products need to be obtained every day.
In this case, the operation of the rebar bending machine may be overloaded. In fact, this is not the case in general, but I think if you operate the power supply for 24 hours, any machine will not be able to withstand such high-load operation. Therefore, when working, you need to pay attention to take a break and let the rebar bending machine "buffer" a bit. Otherwise, in case of failure, it will not be worth the loss.